SN-C406

Features

• DC12V/24V voltage input, safe and reliable, wide range of application.DC12V-Each led can be cut，DC24V -two led can be cut
• Constant current drive, ensure LED brightness consistency and uniformity of the light box
• The light source adopts SMD3030, with 3 EPISTAR 14*28 luminous chips, high brightness, low light decay, good color, long life and good stability.
• Adopt 1.6mm thick and high heat conduction aluminum substrate for heat dissipation to improve the service life of the product.
• Using 10X60°optical lens, the light is scattered from two directions to ensure the uniformity of the light source, no macular spot, and the irradiation distance is up to 1.5m.
• Patch terminal connection for easy installation and maintenance.

Light Distribution

Using parameter

Dimension(mm)

Installation electrical diagram

Layout diagram

Installation schematic description: the test panel is 3mm thick acrylic white board, and the light transmittance is about 54.4%. Aluminum alloy is selected as the light box model, which is evenly arranged according to the photoelectric performance parameters of the product

LED light efficiency data

Setup Warning

1. the mainline of the power supply shall use a cable of more than 2×1.5mm squared. If the power line of the straight lamp needs to be extended, it shall choose a wire of specifications of more than 2.5mm squared /14# to avoid excessive heating of the power line caused by overload and adverse consequences. The length of the power line between the switching power supply and the straight lamp shall not exceed 3 meters, otherwise the line loss will increase and the total power will increase.
2. please use the wiring scheme in the connection diagram, with a maximum cascade of 20PCS, which requires power connection from end to end. There are several ways of power supply output and several ways of power supply to the light bar, so as to prevent overload of single power supply output and damage of power supply.
3. when installing the straight lamp, screw the screw into the hole of the fixing frame and lock it tightly. After lighting for a long time, do not suspend the installation;
4. when there is a bare conductor at the end of the straight lamp, first peel the wire about 10mm with diagonal pliers and screw it into the wiring head for insulation protection.
5. to ensure waterproof and anticorrosive, after the power cord is screwed into the terminal head, it is recommended to inject the terminal head with single-component silica gel (or neutral glass glue or waterproof grease) to protect the exposed copper wire covering the power cord;
6. do not live touch or live operation of this product;
7. it is recommended to use the switch power (with short-circuit protection, overvoltage protection and overcurrent protection) with 80% power.

Packaging

Packing instruction

Use electrostatic bag packaging：550*50*0.15mm

Inner box packing size：520*38*30mm

Carton size：535*280*325mm

20PCS/ layer, 200PCS in 10 layers per box

NW:23.6(1±10%)kg

GW:24.3(1±10%)kg

Note: the above package quantity and weight only refer to the package as shown in the figure. When other packages are used,

the package quantity and weight will be different. The actual package shall prevail.